HI-3804 Industrial Compliance Meter User Manual
10 Maintenance www.ets-lindgren.com Service Procedures CONTACTING ETS-LINDGREN Note: Please see www.ets-lindgren.com for a list of ETS-Lindgren off
www.ets-lindgren.com Specifications 11 3.0 Specifications Readout Specifications Operating Life: Approximately 40 hours Probe Connectivity: 5-pin
12 Specifications www.ets-lindgren.com Probe Specifications Frequency Range: 10 MHz–42 MHz Frequency Bands: Three: 10 MHz–20 MHz 20 MHz–35 MHz
www.ets-lindgren.com Operation 13 4.0 Operation CAUTION: Before placing into operation, follow the safety information in the ETS-Lindgren Product
14 Operation www.ets-lindgren.com Note: Not all of the symbols are active on the HI-3804. Symbol / Indicator Description Under Range Bar Graph
www.ets-lindgren.com Operation 15 Keypad Description Caution: The HI-3804 keypad is comprised of membrane switches. To activate a switch, press ge
16 Operation www.ets-lindgren.com MODE SELECT The keypad uses a matrix for the top three rows of keys. The function of each key depends on the locat
www.ets-lindgren.com Operation 17 To return to AUTO RANGE mode, press and hold RANGE for two seconds until AUTO displays. MAX Note: The maximum val
18 Operation www.ets-lindgren.com BAT Displays battery status. After BAT is pressed, the battery voltage displays for two seconds and then the reado
www.ets-lindgren.com Operation 19 PREV Accesses the last value stored in datalog memory. When PREV is pressed, the three-digit identification number
ii www.ets-lindgren.com ETS-Lindgren Inc. reserves the right to make changes to any products herein to improve functioning or design. Although the in
20 Operation www.ets-lindgren.com ZERO Transmits a zero command to the probe. This zeroes all ranges and axes, which includes both sets of sensors,
www.ets-lindgren.com Operation 21 For accurate readings, follow these guidelines: The arm holding the probe should extend away from your body as
22 Operation www.ets-lindgren.com When the measured field strength is below 5% of full scale for the range being used, the under range indicator ( ◄
www.ets-lindgren.com Warranty 23 Appendix A: Warranty Note: See the Product Information Bulletin included with your shipment for the complete ETS-
24 Warranty www.ets-lindgren.com This page intentionally left blank.
www.ets-lindgren.com EC Declaration of Conformity 25 Appendix B: EC Declaration of Conformity
www.ets-lindgren.com iii Table of Contents Notes, Cautions, and Warnings ... v 1.0 Introduction ...
iv www.ets-lindgren.com Zeroing ... 21 Appendix A: Warranty
www.ets-lindgren.com v Notes, Cautions, and Warnings Note: Denotes helpful information intended to provide tips for better use of the product. Caut
vi www.ets-lindgren.com This page intentionally left blank.
www.ets-lindgren.com Introduction 7 1.0 Introduction The ETS-Lindgren Holaday HI-3804 Industrial Compliance Meter is a portable, battery-operated
8 Introduction www.ets-lindgren.com This page intentionally left blank.
www.ets-lindgren.com Maintenance 9 2.0 Maintenance CAUTION: Before performing any maintenance, follow the safety information in the ETS-Lindgren
Commentaires sur ces manuels